How to login MC5 WebUI and set up radio protocol
How to login MC5 Web UI and Set up Radio Protocol
1. Find and connect MC5’s Wi-Fi.
2. Input password “unis1234”.
3. Input IP address 192.168.10.1 in browser.
4. Click SETTINGS ——> Radio to set up protocol.
Note:
1. Currently Frequency setting is not ready, please use default frequency when using.
2. TransEot is equal to PCC-GMSK protocol.
Related Articles
How to export NMEA data through WebUI
How to export NMEA data through WebUI ——For Unicore board Upgrade MC5 firmware to the newest version Cut off all power supplies and wait for more than ten seconds for the new firmware configuration to complete Log in to the webUI(Password: unis1234), ...How to update by WebUI
1、Connect hotspot of MC5，The MC5 hotspot password is unis1234 2、Enter website 192.168.10.1， If the interface displays abnormally, please refresh it several times 3、Click SYSTEM 4、You can select the project you want to upgrade 5、Then select upgrade ...What if the receiver cannot get fixed?
Attached the document how to find out the reason causing receiver not getting fixed.Calibration steps of hydraulic system
Calibration steps of hydraulic system In order to make the hydraulic system work normally, only three places need to be adjusted——Min Current, P , STEERING CHECK. Make sure that the angle sensor is running normally in advance. Set “p” as 10, others ...Simulator Operating Instruction
Simulator Operating Instruction First, set the control mode to Encoder(the original DEMO mode has been deleted, the simulator only supports this mode) Go to Settings ----> Advanced Settings, select “Emulator Setting”, if turn on or off the emulator ...