How to finish GNSS board reset through PC serial tool
How to finish GNSS board reset through PC serial tool
- Connect the PC to the DB9 connector.
- Open sscom5.13.1.exe software, select current port, and open the port
- Input “unlog” here to close all output statements, remember to check “AddCrLf” button, and then click “send”
- Input “freset” here, and then click “send”
- Then the GNSS Board reset is finished, switch all off, wait a moment, re-powering.
Related Articles
How to check your GNSS board firmware information
How to check your GNSS board firmware information? From main firmware version 0.24.220812, we are no longer showing GNSS board information on the WebUI. If you need to know for which GNSS board and GNSS board firmware version your GNSS receiver is ...How to query frequency signals that are not tracked by the board
How to query frequency signals that are not tracked by the board Connect the PC to the DB9 connector. Open sscom5.13.1.exe software, select current port, and open the port. 3. Input “mask BDS” and click “send”, remember to check “AddCrLf” button, you ...How to upgrade by U disk
How to upgrade by U disk Prepare the upgrade file RinoTrack.apk ----- EAG software must be named as this format devfrm --- Other parts program folder Description of devfrm upgrade file list Description of “devfrm” file details list: (Each program ...Recovery receiver WiFi tutorial
Recovery receiver WiFi tutorial Note：If you can't find your receiver's wifi or forget your receiver's wifi password, please follow this tutorial to recover it. 1. Make sure the receiver's Bluetooth can be searched 2. Install and activate Surpad. ...How to export NMEA data through WebUI
How to export NMEA data through WebUI ——For Unicore board Upgrade MC5 firmware to the newest version Cut off all power supplies and wait for more than ten seconds for the new firmware configuration to complete Log in to the webUI(Password: unis1234), ...