How to export NMEA data through WebUI

How to export NMEA data through WebUI


How to export NMEA data through WebUI

β€”β€”For Unicore board

  1. Upgrade MC5 firmware to the newest version


  1. Cut off all power supplies and wait for more than ten seconds for the new firmware configuration to complete


  1. Log in to the webUI(Password: unis1234), and you will find that there is a β€œMessage” option in the settings

   

  1. You can configure exporting NMEA data here.


    • Related Articles

    • How to update by WebUI

      1、Connect hotspot of MC5，The MC5 hotspot password is unis1234 2、Enter website 192.168.10.1， If the interface displays abnormally, please refresh it several times 3、Click SYSTEM 4、You can select the project you want to upgrade 5、Then select upgrade ...

    • How to login MC5 WebUI and set up radio protocol

      How to login MC5 Web UI and Set up Radio Protocol 1. Find and connect MC5’s Wi-Fi. 2. Input password “unis1234”. 3. Input IP address 192.168.10.1 in browser. 4. Click SETTINGS ——> Radio to set up protocol. Note: 1. Currently Frequency setting is not ...

    • What if the receiver cannot get fixed?

      Attached the document how to find out the reason causing receiver not getting fixed.

    • How to check your GNSS board firmware information

      How to check your GNSS board firmware information? From main firmware version 0.24.220812, we are no longer showing GNSS board information on the WebUI. If you need to know for which GNSS board and GNSS board firmware version your GNSS receiver is ...

    • Recovery receiver WiFi tutorial

      Recovery receiver WiFi tutorial Note：If you can't find your receiver's wifi or forget your receiver's wifi password, please follow this tutorial to recover it. 1. Make sure the receiver's Bluetooth can be searched 2. Install and activate Surpad. ...